Stick Point Tester VMP
1.1 General information
Stick point tester is equipped with a heating mechanism and sensing mechanism which are controlled by Microcontroller and observed on LED 7 segment display.
1.2 General Usage
The stick point tester is used to determine the stick point of thermosetting mixture of the sand and synthetic resin or resin coated silica sand.
1.3 Product Data
Product Name:
Stick Point Tester
Product Code:
VMP
Order Reference Code:
V0000041
Electrical Supply Required:
230v 50Hz A.C. (Default)
110v 60 Hz A.C (Optional)
Single Phase, Stabilized with Over/ Under Voltage cut-off.
Electrical Plug:
M type : 6 Amp Plug
Typical Maximum Current:
1.6 A at 230V
Compressed air Supply:
Not Required
Communication:
Not Applicable
Dimensions:
490x125x240mm (WXBXH)
Packing Dimensions:
690x400x400mm (WXBXH) Typical
Net Weight:
Approximately 10 kg
Gross Weight:
Approximately 16 kg
Colour:
Factory Default
Measuring Range:
0-150 degrees Celsius
Traceable to:
Manufacturers Standards
Least Count:
10C
Specimen Requirements:
Not Required
Operating Temperature:
0-500C
Testing Standards:
BIS: Standard
AFS: Not Applicable
Calibration Frequency:
4600 nos. of Testing Cycles or Once in Year
2.1 Scope of supply
- Stick Point Tester.
- Temperature controller.
- Leaf type sensor.
- Calibration certificate.
- Instruction manual
3.1 Recommended pre-requisite equipment
Hot Air Blower Mixer VHA
4.1 Recommended Calibration kits
VKHC: For Temperature
4.2 Recommended attachments
NA
4.3 Alternative equipment
NA
5.1 Consumables
NA