Hot Shell Tensile Tester VHTD

Description

 

1.1 General information

Hot Shell Tensile Tester is equipped with a loading mechanism, heating mechanism and sensing mechanism which are controlled by Microcontroller or PLC and observed on LCD display. By default it can measure the hot tensile strength.

With Help of attachment it can also measure

• Cold Tensile Strength (Refer 4.2.1)

1.2 General Usage

1.3 Product Data

Product Name:	Hot Shell Tensile Tester M
Product Code:	VHTD
Order Reference Code:	V0000042
Electrical Supply Required:	230v 50Hz A.C. (Default) 110v 60 Hz A.C (Optional) Single Phase, Stabilized with Over/ Under Voltage cut-off.
Electrical Plug:	M type : 15 Amp Plug
Typical Maximum Current:	10.6 A at 230V
Compressed air Supply:	Not Required
Communication:	RS485 MODBUS RTU RS232 Serial Ethernet (Optional) CloudSync using V-Sync
Dimensions:	615 X 385 X 475 mm (WXBXH)
Packing Dimensions:	715 mmx 485mm x 625 mm (WXBXH) Typical
Net Weight:	Approximately 46 kg
Gross Weight:	Approximately 56 kg
Colour:	Factory Default
Measuring Range:	50 Kg/cm2
Traceable to:	NABL Standards
Least Count:	0.05 Kg/cm2
Specimen Requirements:	Not Required
Operating Temperature:	0-50 Degrees Celsius
Testing Standards:	BIS: Standard AFS: Optional
Calibration Frequency:	14500 nos. of Testing Cycles or Once in Year

2.1 Scope of supply

• Hot Shell Tensile Tester.
• Jaw set.
• Tray, Sand sampler & Lifting Tong.
• Calibration certificate.
• Instruction manual.

3.1 Recommended pre-requisite equipment

 

Sand Splitter : To get representative sample

Hot Air Blower Mixer VHA

4.1 Recommended Calibration kits

VKHA: For Dead Weight Hanging

VKHB: Dead Weights

VKHC: For Temperature

4.2 Recommended attachments

VHC: Cold Shell Tensile Strength Attachment

4.3 Alternative equipment

Hot Shell Tensile Tester M VHTD I

5.1 Consumables

NA